Capacitor discharge stud welding equipment : NOMARK 66 D | |||
This new line of stud welding equipments meets the highest
requirements due to operating convenience, low weight, high efficiency, compact design and
absolute safety. The monitoring of all functions is clearly displayed by LED on the front
panel. The short charging cycles increase productivity. Inverter power modules replace traditional heavy transformer rectifiers, are more efficient to use and faster to charge. Lightweight and easily portable, the NOMARK 66 weighs in at around half of many other conventional studwelding equipment. The NOMARK 66 is our capacitor discharge stud welding system that is lightest in weight and lowest in cost.
|
|||
Welding range: | M3 - M8 in Steel and Stainless Steel M3 - M6 in Aluminum and Brass (M8 in Aluminum and Brass after welding tests) |
||
Welding source: | Capacitor battery | ||
Welding process : | GAP and CONTACT | ||
Capacitance : | 66.000 µF | ||
Charging Voltage: | 50 - 200 V ( UP and DOWN ) | ||
Digital Voltmeter : | Yes | ||
Welding time : | 0,001 - 0,003 sec. | ||
Duty cycle: | up till 25 studs / min. | ||
Output power : | 1.320 Ws | ||
Mains supply: | 230 V - 50 / 60 Hz - 10 AT | ||
Size (w x h x l) : | 165 x 250 x 380 mm | ||
Protection: | IP 23 | ||
Insulation Class: | 1 | ||
Weight : | 12 Kg. | ||
|
|||
The super lightweight C1 CONTACT or
G1 GAP welding gun, but rugged, ergonomic design minimizes operator fatigue while maximizing productivity.
Gun body is molded from high-strength, fully insulated, impact and heat
resistant, engineered plastic. G 1 : Reliable mechanical gap system eliminates overheating of electrical "Gap Coils" used by others and minimizes gun weight. The unique mechanical gap mechanism allows for the precise locating of the stud prior to gaping the gun and welding the stud. G1 gun can reduce reverse marking effects on certain gauges of material where the non-welded side is painted or coated. The lightest weight CD Gap Gun in the industry. Infinitely adjustable spring pressure range provides the precision set-up required for difficult applications. Gun configured with tripod legs allow the welding of studs up to 40 mm long. Longer legs or extension kit available for longer studs.
|
|||
Welding range : | M 3 to M 8 | ||
Stud Length: | 6 to 40 mm | ||
Nail length: | 10 à 100 mm | ||
Welding process : | G1 : GAP C1 : CONTACT |
||
Lift settings (for G1) : | Infinitely adjustable | ||
Spring settings (for C1) : | Infinitely adjustable | ||
Cables length : | Gun C1 : 6.5 meters (highly flexible) Gun G1 : 3 meters (highly flexible) |
||
Cables Section : | 25 mm2 | ||
Protection: | IP 2x | ||
Weight : | 0,7 Kg. (without cable) | ||
Accessories : |
Template Tube Ø 30 mm | ||
Extension Kit for studs longer than 40 mmm | |||
Silence Tube Ø 35 mm | |||
Chuck Offset | |||
Tube for Template Ø 20, 26 et 30 mm. | |||
Tool for long studs or nails. | |||
|